4. Based on your rough sketch, did you make any last tweaks? Why? Where all of your measurements acc

Overall I think my rough sketch was pretty well done even though I made a minor tweak. The minor change I made to the sketch was that I changed the top view and cut off extra wood to reduce the mass of the overall dragster. Although I accounted for all my measurements to be as precise as possible there could be a slight error but I attempted my best to account for the nearest mm when trying to figure out the placement of my axle and wheels moreover, when I planned out how much of the back to cut off of my dragster I used precise measurements because if I cut off a bit too much wood, the chances of me cutting into the co2 cartridge hole were greater and the chances of there being a weight imbalance in the car would have also been greater. This overall design is very similar to one of my thumbnail sketches meaning that the details that have made it this far is basically the whole car including the side view, the thickness and the length, but the only thing that was tweaked was the width of the dragster because I made the center more skinnier so the car has a skinnier body.